5-11. Draining sterilizing water
Drain water after the sterilizing water cools down sufciently.
●
Contravention is dangerous with likelihood of scalds because the sterilizing
water is heated immediately after operation.
Open the chamber lid.
Remove the exhaust bottle.
Pull out the drain hose.
Place the drain container below the drain
hose.
Open the drain cock while rotating it slowly
and drain the sterilizing water from the
drain port. When the sterilizing water is not
drained, remove clogging matter by passing
a wire etc. through the drain port.
After draining the sterilizing water
completely, fully rotate the drain cock to
close the drain port completely.
Return the drain hose.
Return the exhaust bottle.
①
②
③
④
⑤
⑥
⑦
⑧
Drain hose
Exhaust bottle
Drain container
(not attached to the autoclave)
Drain port
(Drain valve)
To Next Page
Loading...
