Tonium Pacemaker - Basic Mixing

22
back to top
23
10 Basic mixing
Prepare a track on channel 1
WithlineoutandPhonesconnected
1. Activate Channel 1
2. Place the crossfade indicator at maximum left
3.SelectTrack‘X’fromthetracklist
4.PressPlaytostartplayingTrack‘X’
Prepare a track on channel 2
5. Activate Channel 2
6. Set the phones crossfade indicator to channel 2
7. SelectTrack‘Y’fromthetracklist
8.PressCuetoloadTrack‘Y’atrstbeat
Set cue point of track on channel 2
9.PlayTrack‘Y’onchannel2
10. Locate a desired playback starting position by forwarding or rewinding
11.PressPlaytoDJ-pausethetrack
12. Adjust the current playback position on the Touchpad
13.Whenyou’rehappy,pressCuetosetthecuepoint
Adjust BPM of track on channel 2
14.AdjustthepitchofTrack‘Y’tomatchtheBPMofTrack‘X’
Beatmatch track on channel 2 with track on channel 1
15.Stillinchannel2,makesureTrack‘Y’iscued
16. Adjust Phones monitoring to a suitable blend between the two channels
17.FollowingthebeatsofTrack‘X’,pressPlaywithappropriatetiming
18.Ifnecessary,changepitchorbendpitchuntilthetracksareinphase
19.Whenyou’rehappy,pressCuetosetthecuepoint
Crossfade lineout to channel 2
20.Stillinchannel2,makesureTrack‘Y’iscued
21. Set the lineout crossfade to the middle
22.FollowingthebeatsofTrack‘X’,pressPlaywithappropriatetimingtostart
playingTrack‘Y’
23.OptionallynetunethebeatmatchingbypitchbendingTrack‘Y’
24.CrossfadeLineoutoutputovertochannel2toletTrack‘Y’takeoverthelineout
Prepare a new track on channel 1…