Manual TT-180 - 14 -
11. Control panel
The name plate on the front in the lower left-hand corner shows the following details:
manufacturer and address TOOL-TEMP AG, CH-8583 Sulgen / Switzerland
type TT-180
serial number
Volt
Watt
Hz
sign CE
heating water operation oil operation
I means: step 1 3 kW 3 kW
II means: step 2 6 kW 3 kW
I and II together 9 kW 3 kW
see „Programming:
Temperature controller MP-888“
level control lamp:
pre-warning,not enough
liquid in the unit
ON/OFF-switch
unit
ON/OFF-switch horn:
ON means that in case
of a defect the horn will
be activated
level control lamp:
dropping below the
minimum level
- Unit switches off
Temperature monitoring –
Temperature deviation control:
max. unit temperature
reached – thermostat has
responded. The unit
switches off (pump)
control lamp:
motor overload relay
To Next Page
Loading...