Manual TT-180 - 4 -
DANGER!
- The temperature control unit must not be used in hazardous location.
- The temperature control unit must not be used in the open air (category of protection IP-44).
- The temperature control unit must not be transported in a horizontal position.
- With 9 kW heating power you are only allowed to use water as heat transfer liquid.
With 3 kW oil operation the admitted heat transfer oils or equivalent products have to be used.
WHEN USING UNSUITABLE HEAT TRANSFER OILS
THE UNIT CAN BE DAMAGED WHICH LEADS TO FIRE RISK
AND THEREFOR TO RISK OF INJURY.
4. Installation
Before starting the unit the external connections of the hydraulics and of the electric have to be mounted.
CAUTION!
WHEN STARTING THE UNIT WITHOUT THE PRESCRIBED
CONNECTIONS THE UNIT CAN BE DAMAGED.
CAUTION!
- THE UNIT HAS TO BE INSTALLED IN A SUITABLE LOCATION
ON EVEN GROUND.
- THE UNIT IS NOT PROTECTED AGAINST SPLASH WATER
AND IS NOT SUITABLE FOR USE IN HAZARDOUS LOCATION.
- THE UNIT MUST NOT BE USED IN THE OPEN AIR.
The starting of the unit has to be done in the order of this chapter.
After the proper starting the unit is ready for use.
To Next Page
Loading...
Need help?
General
