Manual TT-188 - 18 -
13. Temperature controller MP-888
cooling switched on
heating switched on
sensor failure
controller is triggered from
external source with a signal of
0-10 V - or 4-20 mA
electronic safety
thermostat
automatic temperature
monitoring / upper and
lower limit contact
programming key:
press the button for
3 sec.
Program steps:
P01 maximum temperature
0-400 °C
(set value +150 °C)
P02 temperature monitoring
limit +/- 20 °C
(set value +/- 5 °C)
see information sheet:
„Temperature controller
MP-888 / programming“
set point
actual value
connections 26 - 28
for external analogue set point
0-10 V oder 4-20 mA
heating
cooling
possible supply voltages –
factory adjusted
current supply
temperature monitoring
(extreme vlaue)
possible heat sensor –
factory adjusted
program version
of the controller
heat sensor connection
set point:
adjustment of the
required temperature
flow control – actual flow value
flow control finger tip (reset)
flow control –
minimum flow
flow control
connections 29 + 30
for external analouge actual value
0-10 V
To Next Page
Loading...