ToolKitRC M6DAC - Page 27

@ ToolkitRC 2021
27
To end the charge and discharge work, short press
[OK], move the cursor to [Stop working], short press
[OK], stop work and return to the main interface.
When charging is completed or an error occurs
during charging, a prompt box pops up and a tone
sounds.
Display content description:
24.00V：
Input power supply voltage
20.0Wh：Total power consumption of input power
45.0℃：Charger internal temperature.
V:
Constant pressure sign.
C：
Constant current sign.
F: Current limit sign. P: power, I: Input overcurrent, C:
Maximum current, A: Activate charging, F: The main
port is full voltage or a single chip is full voltage.
QC: Charge protocol.
12.0V: USB-C output voltage.
2.0A: USB-C output voltage.
25.21V：First channel main port voltage.
20.00A：First channel main port current.
099:00：First channel working time.
888mAh：
Cumulative capacity of the first channel.
1 4.205V：1st battery voltage
.......
4 4.200V：4th battery voltage(this cell is in balance
management)
-.--V ：No battery connected