Need help?Do you have a question about the ToolKitRC M9 and is the answer not in the manual?
Configure the type of battery for charging and discharging.
Set the number of cells in the battery pack.
Choose the operational mode: charge, discharge, or storage.
Select the method for discharging the battery: Inter, Recycle, or External.
Set the maximum input voltage for the discharge recycle mode.
Adjust the terminal voltage control for charge/discharge cut-off.
Set the charge or discharge current for the battery.
Configure the peak voltage for NiMH batteries.
Configure cycle times and rest time for charge/discharge cycles.
Set the wattage for external discharge loads.
Configure settings for smart UAV batteries.
Test the internal resistance of a connected battery.
Analyze PWM, PPM, and SBUS signals.
Generate and test PWM, PPM, and SBUS signals.
Perform a test on Electronic Speed Controllers (ESC).
Use the device as an adjustable power supply.
View details of USB connection and power delivery.
Configure input power source, type, and limits.
Set safety limits for temperature, time, and capacity.
Adjust backlight, volumes, language, and theme.
Restore factory settings and manage default configurations.
Customize the boot image displayed on startup.
Customize voice prompts and alerts.
Update the device firmware via USB.
Utilize USB ports for fast charging other devices.
Configure automatic continuation of charging/discharging.
Manage fan speed based on internal temperature.
Calibrate voltage readings for accuracy.
Behavior of the charger upon full charge completion.
General| Input Current | 10A |
|---|---|
| Battery Types Supported | LiPo, LiHV, LiFe, NiMH, Pb |
| Battery Cell Count | 1-8S |
| Balance Current | 300mA |
| Screen | LCD |
| Operating Temperature | 0-40°C |
To Next Page
