@ToolkiRC 2021
Quick start
1，Connect the 7-35V power supply to the input port on
the back of the M9.
2，The display shows the boot logo and stays for 2
seconds.
3，A welcome sound (voice pack dependent) is played
simultaneously.
4，After booting up, the screen enters the main
interface as shown below:
5，Press and hold [Exit] to enter the auxiliary function
interface.
6，Scroll [Scroll Wheel] to switch between pages.
7，With the charger idle, short press [OK] to set the
charging parameters. Press [OK] during the charging
process to adjust the amperage or stop the charge
process.
8，With the charger idle, Press and hold [OK] to enter
the system setting interface.
9，Short press [Exit] or return to the previous interface.
To Next Page
Loading...
