Need help?Do you have a question about the ToolKitRC M7AC and is the answer not in the manual?
Provides a visual overview and identification of the charger's physical components and ports.
Guides users through the initial setup and basic operation of the M7AC charger.
Allows selection of presets or creation of new battery files. Up to 32 files can be created.
Allows setting the number of cells for the battery, with manual selection or auto-detection.
Allows selection of operating modes such as Charge, Discharge, or Storage.
Configures the discharge method: Normal, Recycle, or External.
Sets the maximum input voltage limit for the recycle discharge mode to prevent overvoltage.
Defines the charge or discharge cut-off voltage for individual battery cells.
Adjusts the charge or discharge current for the selected battery operation.
Configures the peak voltage detection for NiMH batteries to determine full charge.
Sets parameters for battery cycling, including cycle times and rest time.
Sets the wattage for external discharge mode based on the connected load.
Configures settings for smart drone batteries, including model and max current.
Details the interface and operation during active charging or discharging.
Tests the internal resistance of the connected battery.
Analyzes and displays PWM, PPM, or SBUS signal parameters.
Configures and outputs PWM, PPM, or SBUS signals.
Performs a test on the Electronic Speed Controller (ESC).
Configures and starts the adjustable power supply output.
Configures input power related settings like power source and max limits.
Sets safety limits for temperature, time, and capacity.
Customizes display settings like backlight, volume, and language.
Allows customization of the charger's startup boot image.
Manages and customizes voice prompts and sounds for the device.
Instructions for updating the charger's firmware via USB.
Enables the charger to output 5.0V 2.0A to charge mobile devices.
Describes behavior after a lithium battery is fully charged, including trickle charge.
Provides detailed technical specifications for the M7AC charger.
General| Output Voltage | 1-30V |
|---|---|
| Battery Types Supported | LiPo, LiFe, NiMH, NiCd, Pb |
| Balance Current | 300mA |
| Display | 2.4 inch LCD |
| Dimensions | 108x82x29mm |
| Battery Cell Count | 1-6S (LiPo), 1-6S (LiFe), 1-6S (Li-ion) |
To Next Page
