Need help?Do you have a question about the ToolKitRC M6DAC and is the answer not in the manual?
Essential notes on tips, important warnings, and general information for users.
Resources for staying updated with news, information, and firmware for the charger.
Select or create battery types (LiPo, LiHv, LiFe, Lion, NiMh, PB, Power).
Set battery cell count and working mode (Charge, Discharge, Storage).
Configure discharge modes, input voltage limits, and charge/discharge currents.
Adjust end voltage (TVC), NiMH PeakV, and cycle settings for specific battery types.
Configure power source, max power, max current, and voltage range.
Set safety parameters like temperature, time, capacity, and continuous work.
Adjust backlight, buzzer, language, and restore default settings.
Update device firmware and use USB-C for mobile device charging.
Features like auto-continue, fan control, and manual voltage calibration.
Behavior upon reaching full charge, including trickle charging.
General| Battery Types Supported | LiPo, LiFe, Li-ion, LiHV, NiMH, NiCd, Pb |
|---|---|
| Balance Current | 300mA |
| USB Output | 5V/2.1A |
| Cell Count LiPo/LiFe/Li-ion/LiHV | 1-6S |
| Display | LCD |
| Cell Count NiMH/NiCd | 1-15S |
To Next Page
