Topcom BUTLER 930 - Removing a Handset; Using Multiple Handsets; Calling Another Handset

Butler 930 23
Butler 930
ENGLISH
13.2 Removing a handset
It is possible to cancel subscription of a handset to a base. You should do this if a handset is
damaged and has to be replaced by a new one.
• Press the left ‘Menu’ key.
• Press the up or down key
/ repeatedly until ‘BS Settings’ is selected.
•Press ‘Select’ to confirm.
• Press the up or down key
/ repeatedly until ‘Terminate HS’ is selected.
•Press ‘Select’ to confirm.
• Enter the PIN code and press ‘OK’.
• Use the up or down key
/ to select the handset. If you select the current
handset or a non-existing handset, a warning tone will be heard.
•Press ‘Select’ to confirm your selection or press ‘Back’ to leave the menu.
13.3 Selecting a base unit
If your handset is subscribed to several base unit stations (max. 4), you must select a base
unit because the handset can only communicate with one base unit at a time.
• Press the left ‘Menu’ key.
• Press the up or down key
/ repeatedly until ‘HS Settings’ is selected.
•Press ‘Select’ to confirm.
• Press the up or down key repeatedly until ‘Select Base’ is selected.
•Press ‘Select’ to confirm.
• Use the up or down key
/ to select the base. If you select the current a non-
existing base, a warning tone will be heard.
• The display will show ‘Selected BSx’. Press the ‘Select’ key to confirm.
13.4 Using multiple handsets
13.4.1 Calling another handset
• Press the internal call key .
•‘Intercom 1 2 3 4 5” appears on the display.
• Dial the number of the handset you would like to call.
• After finishing your call, press the on hook key to hang up.
Each handset can be subscribed to 4 different DECT base units. Each
base unit is assigned a number from ‘1’ to ‘4’ in the handset. When
you subscribe a new handset, you can assign a base unit number. It
is best to use ‘1’.
You can only cancel subscription of another handset, not the
handset you are using to do the remove procedure.
Caution: Before you can select a base unit, the handset must be
subscribed to the base first.
These functions are only possible when more than one handset is
subscribed to the base.
15
7
15
7
15
7
13
5
15
7
15
7
14
6