Topcon DS-101AC - Page 5

iv
CONTENTS
(Horizontal Angle 0°) ..................................................................... 58
11.2 Setting the Horizontal Angle to a Required Value
(Horizontal Angle Hold) ................................................................. 59
11.3 Turning the Instrument from the Reference Angle to
a Specified Angle .......................................................................... 60
11.4 Angle measurement and Outputting the Data ............................... 61
12. DISTANCE MEASUREMENT.............................................. 62
12.1 Returned Signal Checking ............................................................. 62
12.2 Using the Guide Light in Distance Measurement .......................... 64
12.3 Distance and Angle Measurement ................................................ 65
12.4 Distance Measurement and Outputting the Data .......................... 66
12.5 REM Measurement ....................................................................... 67
13. COORDINATE MEASUREMENT ........................................ 69
13.1 Entering Instrument Station Data .................................................. 69
13.2 Azimuth Angle Setting ................................................................... 70
13.3 3-D Coordinate Measurement ....................................................... 73
14. RESECTION MEASUREMENT ........................................... 75
14.1 Coordinate Resection Measurement ............................................. 76
14.2 Height Resection Measurement .................................................... 80
15. SETTING-OUT MEASUREMENT........................................ 85
15.1 Using the Guide Light in Setting-out Measurement ....................... 85
15.2 Distance Setting-out Measurement ............................................... 86
15.3 Coordinates Setting-out Measurement .......................................... 90
15.4 REM Setting-out Measurement ..................................................... 94
16. OFFSET MEASUREMENT.................................................. 96
16.1 Offset Single-distance Measurement ............................................ 96
16.2 Offset Angle Measurement ............................................................ 98
16.3 Offset Two-distance Measurement ............................................. 100
17. MISSING LINE MEASUREMENT...................................... 103
17.1 Measuring the Distance between 2 or more Points ..................... 103
17.2 Changing the Starting Point ........................................................ 105
18. SURFACE AREA CALCULATION..................................... 107
19. CHANGING THE SETTINGS ............................................ 111
19.1 Observation Conditions ............................................................... 111
19.2 Instrument Configuration ............................................................. 114
19.3 EDM Settings .............................................................................. 116