10 SETTING ATMOSPHERIC CORRECTION
10-11
2.3 開啟電源
c 先將儀器整平。
d 打開電源。
e 搖動望遠鏡直到儀器設定好垂直度盤之0度位置。
若有設定水平度盤之零度之偵測模式，則須旋轉儀器。
開啟電源
TOPCON GTS-700
旋轉望遠鏡與儀器
14-12-94 15:30:40
Prog Std Mem Comm Adj Para
主畫面
z 先確認電池之剩餘電量後，再決定是否取下充電或更換已充飽的電池。
z 參閱 2.4 " 電池之剩餘電量顯示 "。
Note : For setting the vertical angle at 0°, an electronic datum 0 is
provided on the vertical angle circle. If the telescope is turned
and the sensor passes the datum 0, angle measurement begins.
The datum 0 is placed near the level position of the telescope,
the vertical angle setting of 0 can easily be set by rotating the
telescope.
電池之剩餘電量顯示
To Next Page