Surveying with the Receiver
P/N 7010-0626 www.topconpositioning.com
3-13
Figure 3-9. Rover MINTER Configuration
NOTICE
NOTICE
Both Base and Rover receivers must collect data from
common satellites at a common data recording rate and
with identical elevation mask angles.
3. Set up the Rover at an unknown point and press power.
Allow the Rover to collect static data for two to ten
minutes. The REC LED will be orange.
4. Check the STAT light for satellites tracked.
5. When finished, press the FN key for less than a second
to assign the Rover to kinematic.
TIP
TIP
If the REC LED blinks green, the current mode is
dynamic, if it blinks orange, the current mode is static.
To Next Page
