Copyright © 2010 Topscan Ltd. All Rights Reserved.
Scanning corrections
Scanmarker will often recognize if your scan was not been performed correctly, and will
advise you on how to improve your scanning technique. These error messages will appear
as short animations in the middle of your screen after each incorrect scan.
You may choose to set the warnings to appear either as "info balloons" in the bottom
right-hand-corner of your screen or with descriptive animations.
To set scanning corrections options, select Settings from the menu, then select Scanning
Method TAB, below “scan error notifications”, you may check or uncheck the checkbox
that says: “Display scanning errors and corrections”.
If you would like to receive scanning corrections check it and choose either:
- Show corrected scanning techniques with descriptive animations or
- Show corrected scanning techniques as info balloons.
This way you configure Scanmarker to teach you the best way of scanning.
There are three common types of scanning errors:
1. Your scan was too slow. For better results, try scanning slightly faster in
one fluid motion.
2. Your scan was not fluid. For better results, slide the scanner in one fluid
motion while applying minimal pressure.
3. Your scan went out of line. For better results, please keep the scanned
line between the two sharp ends of the clear tip.
Changing Modes
Whenever you change a mode in Scanmarker you should be able to see the changed
mode with a check sign on the left side of it. Also, a balloon should popup from
Scanmarker icon describing the change you have just made.
For example, if you changed the mode to “Scan as Text” a check sign will appear next to
it , and a popup balloon from Scanmarker icon that says:
Scanmarker
Scan Mode : Scan as text
To Next Page
Loading...