13
1. Upon removing the jumper and pressing the RESET key,
the unit will be configured as a 1 channel momentary ON
and OFF. ONLY CH1 will need to be programmed. CH2
can still be viewed and programmed but will not take effect.
2. A 2 second closure between terminals 3 and 4 at ON
event and 2 second closure between terminals 5 and 6 at
OFF event.
12.0 NOTES:
1. MAN mode: Under this mode the unit disregards the
settings in the schedule mode and remains in its manually
set status ON or OFF. To resume regular schedule execution
press the mode key to return to AUTO mode.
2. Unit will go to RUN MODE automatically (except on the
MAN mode) if no key is pressed for 5 minutes.
3. Clear all memory. All memory can be cleared using the
following procedure: While in the RUN mode, press ENTER,
display will show Clear OFF:
Use EVENT key to display Clear ON:
Now press ENTER briefly and everything in the timer memory
will be erased, including real time and date.
NOTE: Unit has permanent memory and will not be erased
unless done through procedure above.
ON
AUTO
AUTO
OFF
To Next Page
Loading...
Need help?
General
