4
PROGRAMMING YOUR EWZ101C STARTS WITH
STEP 2.0
PROGRAMMING YOUR EWZ201C STARTS WITH
STEP 1.0
NOTE: AFTER MAKING ANY CHANGES TO THE
PROGRAM, PRESS MODE TO GO TO RUN MODE AND
THEN PRESS EVENT TO UPDATE THE LOAD STATUS.
1.0 TWO CHANNEL / ONE CHANNEL SELECTION.
The first time unit is powered up, display will show a flash-
ing 2CH.
1.1 For 2 CHANNEL Operation.
Press ENTER then go to section 2.0.CLK (clock) mode.
1.2 For 1 CHANNEL DPST operation.
Press DEL and display will show a flashing 1CH.
Press ENTER to save change and go to section 2.0.CLK
(clock) mode.
2.0 TO SET CLOCK.
The display will show:
AM
CLK
To Next Page
Loading...
Need help?
General
