5
NOTE: WHEN USING ANY ELECTRICAL APPLIANCE, BASIC
PRECAUTIONS SHOULD ALWAYS BE FOLLOWED.
WARNING: To reduce the risk of fire, electric shock or injury:
Do not leave appliance when plugged in. Unplug from outlet when not in use and before
servicing. Turn off all controls before unplugging. To unplug, grasp the plug, not the cord.
Before attempting any maintenance or adjustment, disconnect air lines. Turn off all controls and
air supply at the drop before disconnecting air lines.
To avoid electric shock, do not expose to rain – store indoors.
Do not allow to be used as a toy. Use caution near children.
Use only as described in this manual. Use only manufacturer’s recommended attachments.
If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped
into water, return it to a service center.
Do not pull or carry by cord, use cord as a handle, or pull cord around sharp edges or corners.
Do not run appliance over cord. Keep cord away from heated surfaces. Do not handle plug or
appliance with wet hands.
Do not put any object into openings. Do not use with any opening blocked; keep free of dust,
lint, hair and anything that may reduce air flow.
Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
Do not use to pick up any flammable or combustible liquids such as gasoline or use in areas
where they may be present.
Use extra care when cleaning on stairs.
Do not use without dust bag and/or filters in place. ALWAYS REPLACE WORN OR TORN
EXTERNAL FILTERS IMMEDIATELY to prevent possible injury due to flying object.
NEVER OPERATE UNIT WITH INTAKE UNGUARDED. Keep hair, loose clothing, fingers, and all
parts of body away from openings and moving parts. Strong suction can pull fingers or clothing
into dangerous blades/or moving parts.
ALWAYS POINT THE EXHAUST PORT IN A SAFE DIRECTION AND WEAR SAFETY
GLASSES WHEN IN THE VICINITY OF THIS UNIT. Air leaves the blower at a high velocity.
When the unit is hand held, HOLD FIRMLY WHEN STARTING. High starting torque will cause
unit to jerk and may cause injury or damage.
Before operating your TORNADO Equipment, make sure the voltage and current used are the
same as indicated on the nameplate.
SAVE THESE INSTRUCTIONS
https://harrissupplyind.com - To Order Parts Call 608-268-8080