Tornado 99685 BR 18/11

3
GENERAL SAFETY
RULES
The rules below have to be
followed carefully in order
to avoid injuries to the
operator and damages to the
machine.
- Read the labels carefully
on the machine. Do not
cover them for any reason
and replace them
immediately if damaged.
- The machine must be used
exclusively by authorized
staff who has been
instructed for its use.
- During the working of the
machine, pay attention to
other people, especially
children.
- Do not mix different
detergents, avoid harmful
odors.
- Do not place any liquid
containers onto the
machine.
- Storage temperature:
between 33°F and +110°F.
- Perfect operating
temperature: between 33°F
and 104°F.
- The humidity should be
between 30 and 95%.
- Do not use the machine in
an explosive atmosphere.
- Do not use the machine as
a means of transport.
- Do not use acid solutions
that could damage the
machine and/or injure
people.
- Avoid working with the
brush when the machine
stands still in order to
prevent floor damages.
- Do not use the machine on
surfaces covered with
inflammable liquids or dust
(for example hydrocarbons,
ashes or soot).
- In case of a fire, use a
powder fire extinguisher.
Do not use water.
- Do not strike shelvings or
scaffoldings, where there is
danger of falling objects.
- Adapt the working speed
to the adhesion conditions.
- The machine has to carry
out simultaneously the
operations of washing and
drying.
- Signal the areas of wet
floors with suitable signs.
- If the machine does not
work properly, check by
conducting simple
maintenance procedures.
Otherwise, ask for technical
advice to an authorized
assistance center.
- Where parts are required,
ask for ORIGINAL spare
parts to the distributor
and/or to an authorized
dealer.
- Use only ORIGINAL
brushes.
- For any cleaning and/or
maintenance operations,
take off the power supply
from the machine.
- Do not remove covers on
areas that require the use of
tools.
- Do not wash the machine
with direct water jets or
with high water pressure,
nor with corrosive material.
- Every 200 working hours
have a machine checked
through an authorized
service department.
- In order to avoid scales on
the solution tank filter, do
not fill the detergent
solution many hours before
the machines’ use.
- Before using the machine,
check that all panels and
coverings are in the
position as indicated in this
use and maintenance
catalog.
- Be sure the recovery tank
is empty before removing
it.
- Restore all electrical
connections after any
maintenance operation.
- Provide for the scrapping
of the material of normal
wear following strictly the
respective rules.
- When your machine has
to stop activity, provide for
the appropriate waste
disposal of its materials,
especially oils, battery and
electronic components.
Consider that the machine
itself has been constructed
by recyclable materials.