18
ASSEMBLY
DETERGENT SOLUTION TANK
Grab the hose cap (1) located on the left side of the machine, pull out the hose and after
opening the cap, connect the hose to the water valve. Fill the solution tank with clean water
at a temperature not over 122°F (50°C). Add detergent solution with the concentration provided
by the manufacturer. To avoid the excessive production of foam that could cause damages to the
suction motor, use a minimum percentage detergent solution. On the rear part of the machine is
located the water level hose, which allows users to see the amount of detergent solution inside
the tanks, both when loading it and when working.
Always use a foam-controlled detergent. To safely avoid the production of foam, before starting
to work, add also a small amount of anti-foam solution in the recovery tank.
Never use pure acids.
WORK
A safety device prevents the machine’s movement if the operator is not properly placed on the
footboard.
To turn on the machine:
1. Step on the footboard.
2. Turn the key (1) clockwise to turn on the machine.
3. Check the battery level on the display.
The machine will go automatically in manual mode (MAN).
4. Select the driving direction using the lever (2).
MANUAL MODE WORK
1. Check that the machine is set in manual mode, if not press button (1) and the display will show
the corresponding symbol.
To Next Page
Loading...
Need help?
General