Chassis Maintenance
Adjusting the Cargo-Bed
Latches
If the cargo-bed latch is out of adjustment, the cargo
bed vibrates up and down as you drive the machine.
Y ou can adjust the latch posts to make the latches
hold the cargo bed snugly to the chassis.
1. V erify that the cargo bed is latching.
Note: If the cargo bed does not latch, the
bed-latch striker is likely too low . If the cargo
bed latches, but vibrates up and down as you
drive, the bed-latch striker is likely too high.
2. Raise the cargo bed; Raising the Cargo Bed to
the Dump Position ( page 22 ) .
3. Loosen the 2 bolts on the bed-latch striker and
move the striker up or down, depending on if the
striker is too high or too low ( Figure 59 ).
g034451
Figure 59
1. Bolts 2. Bed-latch striker
4. T ighten the 2 bolts on the bed-latch striker
( Figure 59 ).
5. V erify that the adjustment is correct by latching
the cargo bed several times.
Cleaning
W ashing the Machine
Service Interval : Before each use or daily —W ash
the machine.
W ash the machine as needed using water alone
or with a mild detergent. Y ou may use a rag when
washing the machine.
Important: Do not use brackish or reclaimed
water to clean the machine.
Important: Pressurized water is not
recommended when washing the machine. It may
damage the electrical system, loosen important
decals, or wash away necessary grease at friction
points. A void excessive use of water , especially
near the control panel, motor , motor controller ,
charger , back of the dashboard, and batteries.
47
To Next Page
Loading...
