Toro 07433LT - Setup; Installing the Steering Wheel

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure Description
Qty .
Use
Steering wheel
1
Locknut 1
Wheel cover 1
1
Screw
3
Install the steering wheel (international
models only).
2
No parts required
–
Charge the machine.
3
No parts required
–
Check the uid levels and tire pressure.
4
No parts required
–
Burnish (break-in) the brakes.
Operator's Manual
1
Registration card 1
Predelivery Inspection Form 1
Certicate of Quality
1
5
Key 2
Read the Operator's Manual and view
the setup material before operating the
machine.
1
Installing the Steering
Wheel
International Models Only
Parts needed for this procedure:
1
Steering wheel
1 Locknut
1 Wheel cover
3
Screw
Procedure
1. Place the steering wheel on the steering shaft.
Ensure that the steering wheel is centered
(i.e., the at bottom should be parallel with the
ground).
2. Use the locknut to secure the steering wheel to
the steering shaft.
3. T orque the locknut to 27 N∙m (20 ft-lb).
g424446
Figure 3
9