Toro 08766 - Using the Alignment Guide

Figure13
1.Roller
3.Scraperrod
2.Rollershaft
4.Removetherollershaftfromtheroller(Figure13).
5.Movetherollertothedesireddepthandinstallthe
shaft.Startatthelowsetting1/2to1-1/2inches.
Note:Movingtherollerdownwillraisethecutting
depth.
6.Locktherollerinpositionwiththescraperrod.
UsingtheAlignmentGuide
Thealignmentguideisusedtokeeptheedgerinastraight
linebysightorwhenfollowingastringline.
1.Loosenthescrewandadjustthealignmentguideforor
afttothedesiredposition(Figure11).
2.Aligntheguidewiththestringorlinedesiredtobe
edged.
3.Tightenthescrew .
11