Toro 09200 - Secure Rear Hood; Secure Belt Cover; Install Tine Holders, Turf Guards and Tines

14
Secure Rear Hood
(Required for CE)
1. Secure the hood plate to the rear hood with (3) pop
rivets (Fig. 7).
2. Thread a #10 nut onto a #10 x 2 inch capscrew.
3. Insert the capscrew thru the hood plate (Fig. 7).
1
Figure 6
1. Rear hood
1
3
2
Figure 7
1. Hood plate
2. Pop rivet
3. Capscrew & nuts
4. Secure the capscrew to the hood plate with a # 10
locknut (Fig. 7).
Secure Belt Cover
(Required for CE)
1. Insert a 1/4 x 1 inch capscrew thru the belt cover latch
lever and secure with a 1/4 locknut (Fig. 8 & 9).
1
2
Figure 8
1. Belt cover 2. Latch lever
1
2
Figure 9
1. Latch lever 2. Capscrew & nut
Install Tine Holders, Turf
Guards and Tines
A wide selection of tine holders, turf guards and tines are
available for the aerator. Refer to page 22 for the
installation instructions.