Toro 22215 - Installing the Transmission Belt

10.Rotatetheidlerpulleyovertheaccessholeon
thetransmissionbyusingasocketwrenchto
turntheidler-pulleynut.
g281194
Figure48
1.Socketwrench
3.Accesshole
2.Idler-pulleynut
4.Screwdriver
11.Whileyouareholdingtheidlerpulleyover
theaccessholeonthetransmission,inserta
screwdriverthroughtheaccessholetocatcha
ribontheidlerpulley.
g280736
Figure49
1.Screwdriverthrough
accesshole
3.Idlerpulley
2.Accesshole4.Transmissionbelt
12.Usethescrewdrivertoholdtheidlerpulleyout
ofthewayuntilyouaredoneinstallingthenew
transmissionbelt.
13.Removethehex-headboltandcarriageboltthat
areholdingthetransmissionbracketontothe
frame(Figure50).
g280656
Figure50
1.Transmissionbracket3.Hex-headbolt
2.Carriagebolt
14.Allowthetransmissiontoswingdown.
Note:Ifthetractioncableispulledtootight,
damagemayoccur.Ensurethatthetraction
cableisnotpulledtight.
15.Removethetransmissionbelt.
InstallingtheTransmissionBelt
1.Whiletheidlerpulleyispulledoutoftheway,
installthenewtransmissionbelt.
2.Usethehex-headboltandcarriagebolt,
removedinStep13ofRemovingthe
TransmissionBelt(page31)tosecurethe
transmissionbracketontotheframe.
3.Removethescrewdriverfromtheaccessholein
thetransmissiontoreturntheidlerpulleytoits
tensionedposition.
4.Usetherear-viewingwindow,locatedunderthe
rear-dischargedeector,toensurethatthenew
transmissionbeltispositionedcorrectly.
5.Installthetrailingshieldusingthe2
trailing-shieldboltsremovedinStep9of
RemovingtheTransmissionBelt(page31).
6.Installtherear-viewingwindow,located
undertherear-dischargedeector,usingthe
correspondingboltremovedin8ofRemoving
theTransmissionBelt(page31).
32