Toro 23210 - Page 34

Figure51
1.Tractioncontrol
2.Stem,boltandnut
5.Adjustthetractioncontrolsothatitrestsush
againstthereferencebarwhenitispulledstraight
back(
Figure51andFigure52).
Figure52
6.Tightentheangenutandboltinthetraction
controlstem.
7.Starttheengine.
8.Drivethemachineinreversewiththetraction
controltighttothereferencebar.Ifthemachine
doesnotbackupstraight,completethefollowing
procedure:
A.Stoptheengine
B.Lift/supportthemachinesothatbothtracksare
offofthegroundandarefreetorun.
C.Loosentheangenutandboltinthestemofthe
tractioncontrol(
Figure51).
D.Loosenthejamnutsonthetractionrods,under
thecontrolpanel(
Figure53).
G01 1476
1
1
2
2
Figure53
1.Tractionrod2.Jamnut
E.Startthemachineandsetthethrottletoabout
1/3openposition.
WARNING
Whenthemachineisrunning,youcould
becaughtandinjuredinmovingpartsor
burnedonhotsurfaces.
Stayawayfrompinchpoints,movingparts,
andhotsurfaceswhenadjustingtherunning
machine.
F.Haveahelperholdthetractioncontroltightto
thereferencebarinreverse.
G.Adjustthelengthofthetractionrodsuntilboth
tracksarerunningatthesamespeed.
Note:Youcanalsoadjustthemaximumreverse
speedofthetracksatthistime.
H.Tightenthejamnuts.
I.Adjustthetractioncontrolsothatitrestsush
againstthereferencebarwhenitispulledstraight
back(
Figure51andFigure52).
J.Tightentheangenutandboltinthetraction
controlstem.
K.Stoptheengineandlowerthemachinetothe
ground.
L.Drivethemachineinfullreverse,checkingto
seeiftheunittracksstraight.Ifitdoesnot,
notethedirectionthemachineveers.Repeatthe
adjustmentpreviouslydescribedsothatittracks
straightinreverse.
34