GROUND DRIVE & TINE SYSTEMS
5-11
Toro 30” Aerator Service Manual
5
8. Rotate the rear wheel until the master link is
accessible. Remove the master link, cover plate, and
spring clip. Remove the chain.
9. Loosen the tensioner for the drive wheel chain (Fig.
206).
12. Remove the three nuts and bolts that secure the jack
shaft plate (Fig. 208).
Fig. 206 drive chn tensioner
10. Rotate the rear wheel until the master link is acces-
sible. Remove the master link, cover plate, and
spring clip. Remove the chain
11. Loosen the set screws on all three ange bearing
assemblies.
Note: There are two set screws per ange bearing
(Fig. 207).
Fig. 207 set screws
Fig. 208 jackshaft plate
13. Slide the bearing and plate off the jack shaft (Fig.
209).
Fig. 209 brg & plate
To Next Page
Loading...
