Toro 30635 - Pre-Maintenance Procedures; Removing the Hood; Lubrication; Greasing the Bearings and Bushings

Pre-Maintenance
Procedures
RemovingtheHood
1.Unlatchandraisethehood.
2.Removethehairpincottersecuringthehood
pivottothemountingbrackets(Figure41).
g031613
Figure41
1.Hairpincotter
3.Slidethehoodtotherightside,lifttheother
side,andpullitoutofthebrackets.
Note:Reversethisproceduretoinstallthehood.
Lubrication
GreasingtheBearingsand
Bushings
ServiceInterval:Every50hours—Lubricateallofthe
bearingsandbushings.
Every500hours/Yearly(whichevercomesrst)
Themachinehasgreasettingsthatyoumust
lubricateregularlywithNo.2lithiumgrease.Also,
lubricatethemachineimmediatelyafterevery
washing.
Thegrease-ttinglocationsandquantitiesare:
TractionUnit
•2frontandrear-axle-pivotbushings(Figure42)
•2steering-cylinder-balljoints(Figure43)
•2tie-rod-balljoints(Figure43)
•2king-pinbushings(Figure43).
Lubricatethetopttingonthekingpin
annually(2pumps).
g004687
Figure42
47