Toro 30635 - Adjusting the Roll Bar; Adjusting the Height of Cut

g011488
Figure17
1.Gearbox2.Check/llplug
AdjustingtheRollBar
WARNING
Toavoidinjuryordeathfromrollover:keep
therollbarintheraisedlockedpositionand
usetheseatbelt.
Ensurethattheseatissecuredwiththeseat
latch.
WARNING
Thereisnorolloverprotectionwhentheroll
barisinthedownposition.
•Donotoperatethemachineonuneven
groundoronahillsidewiththerollbarin
thedownposition.
•Lowertherollbaronlywhenabsolutely
necessary.
•Donotweartheseatbeltwhentherollbar
isinthedownposition.
•Driveslowlyandcarefully.
•Raisetherollbarassoonasclearance
permits.
•Checkcarefullyforoverheadclearances
(i.e.,branches,doorways,electricalwires)
beforedrivingunderanyobjectsanddo
notcontactthem.
Important:Alwaysusetheseatbeltwhenthe
rollbarisintheraisedandlockedposition.Do
notusetheseatbeltwhentherollbarisinthe
loweredposition.
LoweringtheRollBar
Important:Lowertherollbaronlywhen
necessary.
Important:Ensurethattheseatissecuredwith
theseatlatch.
g221650
Figure18
RaisingtheRollBar
g221651
Figure19
AdjustingtheHeightofCut
FrontCuttingUnit
Theheightofcutisadjustablefrom25to127mm(1
to5inches)in13mm(1/2inch)increments.Toadjust
theheightofcutonthefrontcuttingunit,position
thecaster-wheelaxlesintheupperorlowerholesof
thecasterforks,addorremoveanequalnumberof
spacersfromthecasterforks,andsecuretherear
chaintothedesiredhole.
25