Toro 30645 - Mounting the Cutting Unit to the Traction Unit

2.Removethehairpincotterandclevispinsecuringthe
height-of-cutrodtotherearofthecuttingunit(Figure
20).Removetheheight-of-cutcollars.
g017957
1
2
3
Figure20
1.Height-of-cutrod
3.Hairpincotterandclevis
pin
2.Height-of-cutcollar
3.Turnontheignitionswitchandlowerthecuttingunit
totheoor.
Note:LeavetheliftswitchintheFLOATposition.
Note:Makesuretheengineisnotrunning.
4.Removethehairpincottersandclevispinssecuringthe
liftarmstothecastor-armbrackets(Figure21).
g017958
1
2
3
4
Figure21
1.Lift-arm
3.Hairpincotter
2.Clevispin4.Castor-armbracket
5.Removethehydraulicmotorcovers,removethebolts,
thenremovethehydraulicmotorfromthecuttingunit.
(Figure22).
g017959
1
2
3
Figure22
6.Raisetheliftarms,latchthemintheraisedposition,
androllthecuttingunitawayfromthetractionunit.
Turnofftheignitionswitch.
CAUTION
Donotengagethecuttingunitdrivewhile
thehydraulicmotorisnotconnectedtothe
cuttingunit.
MountingtheCuttingUnitto
theTractionUnit
1.Positionthemachineonalevelsurfaceandshutthe
engineoff.Leavetheignitionswitchon.
2.Movethecuttingunitintopositioninfrontofthe
tractionunit.
3.Installthehydraulicmotorontothecuttingunit,secure
itusingthe2bolts,theninstallthe2hydraulicmotor
covers(Figure22).
4.MovetheliftswitchtotheFLOATposition.
5.Pushaliftarmdownuntiltheholesintheliftarmline
upwiththeholesinthecastor-armbracketandthe
height-of-cutrodcanbeinsertedintothelift-armpads
(Figure23).
18