Toro 31050 - Page 297

AssemblingthePTODriveshaft
1.Installthenewcrossandbearingsasfollows:
A.Applyathicklayerofgreasetothebearingboresintheendyokeand
shaftyoke.
B.Press1bearingpartiallyintotheyoke.
C.Insertthecrossintotheyokeandbearing.
D.Holdthecrossinalignmentandpressthebearinginuntilithitstheyoke.
E.Installthesnapringintotheyokegroovetosecureinstalledbearing.
F.Placesecondbearingintotheyokeboreandontothecrossshaft.Press
thebearingintotheyokeandsecurewiththesnapring.
G.Repeattheprocedurefortheotheryoke.
H.Applygreasetothecrossuntilitcomesoutofallthe4bearingcups.
2.Ensurethattheassembledjointmoveswithoutanybinding.Lightlyrapthe
yokelugswithasoft-facedhammertoremoveslightbinding.Ifbinding
continues,disassemblethejointtoidentifythesourceofbinding.
3.InstallthePTOdriveshaftontothemachine;refertoInstallingthePTO
Driveshaft(page8–19).
ProLineH800
Page8–21
AxleandPTO:ServiceandRepairs
19241SLRevB