11
CAUTION
Chemicals are hazardous and can cause
personal injury!
Securely tighten all sprayer hose clamp
connections during initial set-up to
prevent leaks and hose blow-offs while
spraying system is in operation.
Figure 2
1. Boom Hold-In Ass'y. 3. Boom Mounting
2. Angle Crossmember Bracket
5. Attach the Solenoid Assembly to the Angle
Crossmember with four (4) 5/16" hex head cap
screws and hex nuts. (See FIG. 3.)
NOTE: In the following instructions, "sealer"
refers to the Teflon Thread Tape.
1. Apply a heavy coating of grease to the tubes
of the two Boom Mount Assemblies and insert
them into the Vehicle Frame until Stop Pin bottoms
out against Vehicle Frame. (See FIG. 1.)
1139-1
Figure 1
1. Stop Pin 3. 1/2" x 18" screws
2. Boom Mount Ass'y.
2. Using a torque wrench, tighten the 1/2" x 18"
screws that join the Wedges to the Boom Mounts.
Tighten to 50 ft. lbs.
NOTE: If installing the "Enclosed Boom" option
in place of the Standard Boom, DO NOT install
the (2) Boom Hold-In Assemblies in Step 3 or
the (2) Boom Mounting Brackets in Step 4.
.
3. Install the two (2) Boom Hold-In Assemblies
and the Angle Crossmember to the top of the
Boom Mount uprights as shown in FIG. 2, using
four (4) 1/2" x 1-1/4" cap screws, flat washers and
lock nuts.
4. Attach the two "U"-shaped Boom Mounting
Brackets to the bottom of the Boom Mount
uprights with four (4) 1/2" x 1-1/4" cap screws, and
lock nuts. (See FIG. 2.)
SPRAY SYSTEM:
SET-UP INSTRUCTIONS
Figure 3
1. Solenoid Ass'y 2. Angle Crossmember
NOTE: If installing the "Enclosed Boom" option
in place of the Standard Boom, skip steps 6-19.
6. Position a Spacer Tube between the lugs on
each side of the Main Frame tube. Insert a 1/2" x
2-1/2" cap screw through the lugs and spacers.
Secure the Main Frame to the Boom Mounting
Brackets with lock nuts. (See FIG. 4.)
3
3
1
2
1
1140
1015
To Next Page
Loading...
