Toro 41564 - Page 12

12
10. Loosely attach a Single Barb Turret Body with
the Turret Body Clamp to LH end of the Center
Boom Pipe. Loosely attach a threaded Turret Body
with the Turret Body Clamp to RH end of the Center
Boom Pipe.
11. Place two Hose Clamps on two 3/4" x 19"
Jumper Hoses and connect the two "end" Turret
Bodies to the Double Barb Turret Body. Space
nozzles 20" apart and tighten fasteners securely.
Apply thread sealer and install the 90° 3/4" Hose
Barb on the Threaded Turret Body. (See FIG. 5.)
12. Attach the two Strut Assemblies to the two
adjustable clevis' found on each side of the Main
Frame tube with two (2) 1/2" x 2" clevis pins and
two (2) 1/8" x 1" cotter pins. (See FIG. 5)
NOTE: If the optional "Foam Marker Kit" is to
be installed, refer to the instructions furnished
with that kit before proceeding to step 13.
IMPORTANT! DO NOT over-tighten the nuts in
steps 13 and 15. The clamping action could
crush the Boom Pipe.
13. Insert the plugged end of an Extension Boom
Pipe into the Pivot Assembly and secure with four
(4) 1/4" x 1-1/4" cap screws and lock nuts. (See
FIG. 6) Repeat on the opposite side to assemble
the other Extension Boom.
Figure 4
1. Spacer Tube 2. Main Frame
7. Position the two (2) Center Boom angles on
the Main Frame and secure them to the Main
Frame tube with two (2) square U-bolts, four (4)
flat washers and hex nuts. (See FIG. 5.)
8. Center and attach the Center Boom Pipe to
the two Center Boom Angles with two (2) clamps,
(2) 3/8" x 1" cap screws, flat washers and lock nuts.
Once mounted the Center Boom Pipe should be
approx. 20" from ground.
9. Loosely attach the Double Barb Turret Body
with the Turret Body Clamp in the approximate
center of the Center Boom Pipe. For the most
uniform spray coverage, position all Nozzles level
as shown in FIG. 5.
SET-UP INSTRUCTIONS
Figure 6
1. Extension Boom Pipe 3. Boom Support
2. Pivot Assembly Assembly
4. Height Adjustment
14. Attach the LH Boom Support Assembly to the
Pivot Assembly, using a 5/16" x 1-1/2" cap screw
and lock nut. (See FIG. 6 & 7.)
15. Secure the two plates of the Boom Support
Assembly to the Extension Boom Pipe, using two
(2) 1/4" U-bolts, four (4) lock nuts and flat washers.
(See FIG. 7.)
Figure 5
1. Center Boom Angle 8. Jumper Hose
2. Main Frame 9. Strut Assembly
3. U-bolt 10. Adjustable Clevis
4. Center Boom Pipe 11. Turret Body Clamp
5. Boom Clamp 12. Threaded Barb Turret
6. Double Barb Turret 13. 90° Hose Barb
7. Single Barb Turret
1141
1016