14
FRESH WATER TANK (Fig. 11)
1. Mount Brace assembly to the two (2) 5/16"
carriage bolts in the right side front Tank Band
using two (2) 5/16" flat washers and hex nuts.
Tighten securely.
NOTE: Left hold-in assembly and hardware will
not be used.
2. Mount Wash Tank Bracket (open end forward)
to right-hand Hold-In Brace assembly using two
(2) 5/16" x 1" hex hd. cap screws, flat washers,
and hex nuts. Place Clean Water Wash Tank into
Wash Tank Bracket and secure with Rubber Hold-
Down, as shown in FIG. 11.
NOTE: Tighten all fasteners and hose clamps
securely before using the spray system.
NOTE: If installing the "Enclosed Boom" option
in place of the Standard Boom, skip Steps 28-
30 and refer to the instructions furnished with
that kit before continuing with Step 31.
28. Attach the Boom Feeder Hoses to the barbs
in the Solenoids with hose clamps.
29. Place a hose clamp on the center Boom
Feeder Hose and attach it to the 90° Hose Barb at
the RH end of Center Boom Pipe.
30. Place a hose clamp on the right and left Boom
Feeder Hoses and attach them to the double barb
nozzles on the right and left Boom Pipes.
31. Install the "Anti-Siphon Kit". Instructions and
parts are included with your MULTI PRO
®
5500
Turf Sprayer.
NOTE: If installing the optional "Foam Marker
Kit", refer to the instructions furnished with
that kit for remaining set-up procedures.
Figure 11
1. Clean Water Wash Tank 4. Boom Hold-In Ass'y
2. Wash Tank Bracket 5. Hold-In Brace Ass'y
3. Rubber Hold-Down
Figure 10
1. Tee 4. Hose Barb
2. Reducing Bushing 5. Agitator Feed Hose
3. Pump 6. 90° Hose Barb
SET-UP INSTRUCTIONS
27. Apply thread sealer and install Reducing
Bushing into side of Tee on top of Pump. Install 1"
MPT x 3/4" hose barb into Reducing Bushing, and
attach one end of the Agitator Solenoid Feed
Hose. (See FIG. 10) Secure with a hose clamp.
Attach other end of hose to the 90° hose barb at
the side of the Agitator Solenoid. (See FIG. 9)
Secure with a hose clamp.
1142
To Next Page
Loading...
