21
VEHICLE CONTROLS
SPEED CONTROL: Vehicle may be set at a
desired speed. Ground speed will vary slightly in
accordance with the slope of the terrain.
1. ENABLE BUTTON: When depressed,
activates the Speed Control.
2. TOGGLE SWITCH: Turns Speed Control
"ON" or "OFF".
3. INDICATOR LIGHT: When lit, indicates
Speed Control is on.
4. PRESSURE GAUGE: Indicates the pressure
at which the Spray System is operating
.
5. BOOM INDICATOR LIGHTS: When lit,
indicates which Boom section(s) is on.
6. PASSENGER HAND HOLD: Right side of
dash panel.
7. ENGINE OIL PRESSURE WARNING LIGHT:
Indicates dangerously low oil pressure. If light
comes on with the engine running, STOP as soon
as possible and correct the cause of low oil
pressure before restarting the engine.
8. COOLANT TEMPERATURE GAUGE:
Indicates the temperature of the engine coolant
when the ignition switch is in the ON position. The
pointer will move to the NORMAL band as the
engine warms up. When operating in hot weather
or with very heavy loads, the pointer may read at
the very top of the NORMAL band. If the pointer
moves out of the NORMAL band into the H (hot)
position, the engine is overheating and engine
damage may result. If there is no apparent loss
of coolant from the cooling system, idle the engine
for two minutes, then turn off the engine and let it
cool.
9. VOLT METER: Indicates the battery voltage
when the ignition key is in the ON position. After
the engine is started, the pointer will move into
the white marked area, and in normal operation,
remain there. (12.8-14.8 volts) If the pointer
remains in either red marked area, have the
engine's electrical system checked.
10. HOUR METER: Shows total hours that
vehicle has been operated.
11. HEADLAMP SWITCH: Turns Headlamps
ON and OFF.
12. IGNITION SWITCH: NOTE: THIS IS A FOUR
POSITION SWITCH. The "ACC" position is not
used on the MULTI PRO
®
5500 Turf Sprayer. In
the "OFF" position, the switch disconnects the
electrical system from the battery. The key can
be removed from the switch when it is in this
position. In the "ON" position, the electrical system
is activated. Engage the starter by turning the key
to the "START" position. Release the key when
the engine starts and it will return to the "ON"
position.
INSTRUMENT PANEL LAYOUT
1147
To Next Page
Loading...
