30
LUBRICATION
WARNING
Servicing the vehicle while the engine is
running or vehicle is not properly secured,
could result in personal injury or death.
Before servicing or making adjustments
to the vehicle, set parking brake, stop
engine, and remove key from the switch.
The MULTI PRO
®
5500 has 11 grease fittings that
must be lubricated regularly with No. 2 General
Purpose Lithium Base Grease. If the machine is
operated under normal conditions, lubricate all
bearings and bushings every 100 hours of
operation. More frequent lubrication is required if
used for heavy duty vehicle operations.
The grease fitting locations and quantities are: Tie
rod ends (2), Power steering cylinder (2), Front
spindles (2), Drive linkage arms (2), Boom hinges
(2), Governor lever (1). (See Fig. 23-26)
1. Wipe grease fitting clean so foreign matter
cannot be forced into the bearing or bushing.
2. Pump grease into the bearing or bushing.
3. Wipe off excess grease.
Figure 23
1. Steering Cylinder Fitting (one shown; one at other
end of cylinder)
2. Tie Rod End Fitting (one on each side)
3. King Pin Fitting (one on each side)
Figure 24
1. Neutral Centering Arm Fittings (one on each arm)
Figure 25
1. Boom Hinge Fitting (one on each side)
Figure 26
1. Governor Lever Fitting
!
To Next Page
Loading...
