111-1033TH051006
MAINTENANCE
EVERY 50 HOURS Continued.
Grease pivot points : Clean and grease all grease points with a
good quality compound of the grade specified, refer -
SPECIFICATIONS.
Replace any grease nipples which are damaged.
Grease all cutterhead grease points and ensure that sufficient
grease is injected such that clean grease is seen to escape from
the roller end caps. This provides visible evidence that the roller
seals have been purged of grass debris etc. and will ensure
maximum working life.
1.54
1.54
To Next Page
Loading...
Need help?
General
