Toro 72932 - Checking the Tire Pressure; Checking the Wheel Lug Nuts; Checking the Wheel-Hub Slotted Nut; Adjusting the Caster-Pivot Bearing

CheckingtheTirePressure
ForMachineswithPneumatic
TiresOnly
ServiceInterval:Every50hours/Monthly(whichever
comesrst)Formachineswith
pneumatictiresonly.
Maintaintheairpressureinthecastertiresandrear
tiresat90kPa(13psi).Uneventirepressurecan
causeunevencut.Checkthetireswhentheyarecold
togetthemostaccuratepressurereading.
g001055
Figure78
CheckingtheWheelLug
Nuts
Checkandtorquethewheellugnutsto122to129
N∙m(90to95ft-lb).
CheckingtheWheel-Hub
SlottedNut
ServiceInterval:Aftertherst100hours
Every500hours
Checkandensurethatthetorqueoftheslottednutis
286to352N∙m(211to260ft-lb).
Note:Donotuseanti-seizecompoundonwheelhub.
g024121
Figure79
1.Slottednut
AdjustingtheCaster-Pivot
Bearing
ServiceInterval:Every500hours/Yearly(whichever
comesrst)
1.Parkthemachineonalevelsurface,disengage
theblade-controlswitch(PTO),andengagethe
parkingbrake.
2.Shutofftheengine,removethekey,andwait
forallmovingpartstostopbeforeleavingthe
operatingposition.
3.Removethedustcapfromcasterandtighten
thelocknut(Figure80).
4.Tightenthelocknutuntilthespringwashersare
at,andthenbackoffa1/4turntoproperlyset
thepreloadonthebearings(Figure80).
Important:Makesurethatthespring
washersareinstalledcorrectlyasshownin
Figure80.
5.Installthedustcap(Figure80).
57