Toro 74274 - Adjusting the Anti-Scalp Rollers

2.Stoptheengine,removethekey,andwaitforall
movingpartstostopbeforeleavingtheoperating
position.
3.Afteradjustingtheheight-of-cut,adjusttherollers
byremovingtheangenut,bushing,spacer,and
bolt(Figure17,Figure18andFigure19).
Note:Thetwomiddlerollerswillnothaveaspacer
(Figure18).
4.Selectaholesotheanti-scalprollerispositionedto
thenearestcorrespondingheight-of-cutdesired.
5.Installtheangenutbushing,spacer,andbolt.
Torqueto40-45ft-lb(54-61N•m)(Figure17,
Figure18andFigure19).
6.Repeatthisadjustmentontheotheranti-scalp
rollers.
G000942
1
2
3
4
5
Figure17
1.Anti-scalproller4.FlangeNut
2.Spacer
5.Bolt
3.Bushing
G000943
1
2
3
4
Figure18
1.Anti-scalproller3.FlangeNut
2.Bushing4.Bolt
G000944
1
2
3
4
5
Figure19
1.Anti-scalproller4.FlangeNut
2.Spacer
5.Bolt
3.Bushing
AdjustingtheFlowBafe
Themowerdischargeowcanbeadjustedfordifferent
typesofmowingconditions.Positionthecamlocks
andbafetogivethebestqualityofcut.
1.DisengagethePTO,movethemotioncontrol
leverstotheneutrallockedpositionandsetthe
parkingbrake.
2.Stoptheengine,removethekey,andwaitforall
movingpartstostopbeforeleavingtheoperating
position.
3.Toadjustthecamlocks,swingtheleverupto
loosenthecamlock(Figure20).
4.Adjustthebafeandcamlocksintheslotstothe
desireddischargeow.
5.Swingtheleverbackovertotightenthebafeand
camlocks(Figure20).
6.Ifthecamsdonotlockthebafeintoplaceoritis
tootight,loosentheleverandthenrotatethecam
lock.Adjustthecamlockuntilthedesiredlocking
pressureisachieved.
23