Toro 74274 - Controls System Maintenance; Adjusting the Control Handle Neutral Position

12.Installtheoilcoolershieldandenginestrapsto
therearframewiththe4boltspreviouslyremoved
(Figure61).
13.Installtheenginestrapstothesideofthemachine
(Figure61).
14.Tightenthebottomboltandinstalltheupperbolt
holdingthealternatorandcover(Figure63).
TensioningtheAlternatorBelt
1.Placeahandlebetweenthealternatorandcylinder
block.
2.Adjustthealternatortotheoutsideuntilthereis
1/4to11/32inch(7to9mm)deectioninthebelt
betweentheengineandthealternatorpulleyswith
22.1lbsofforce(10kgf)(Figure63).
3.Tightenthealternatorbolts.
4.Checkthedeectioninthebeltagainandadjustthe
beltifneeded.
5.Ifthedeectioniscorrect,tightenthebottomand
upperbolt(Figure63).
G000968
1
2
3
4
5
Figure63
1.Alternator4.Topbolt
2.Alternatorbelt5.Bottombolt
3.Deection,1/4to
11/32inch(7to9mm)with
22.1lbsofforce(10kgf)
ControlsSystem
Maintenance
AdjustingtheControlHandle
NeutralPosition
Ifmotioncontrolleversdonotalign,ormoveeasilyinto
theconsolenotch,adjustmentisrequired.Adjusteach
lever,springandrodseparately.
Note:Motioncontrolleversmustbeinstalledcorrectly.
SeeInstallingtheMotionControlLeversinthesetup
instructions.
1.DisengagethePTO,movethemotioncontrollevers
totheneutrallockedpositionandsettheparking
brake.
2.Stoptheengine,removethekey,andwaitforall
movingpartstostopbeforeleavingtheoperating
position.
3.Unlatchtheseatandtilttheseatforward.
4.Beginwitheithertheleftorrightmotioncontrol
lever.
5.Movethelevertotheneutralpositionbutnotlocked
(Figure64).
6.Pulltheleverbackuntiltheclevispin(onarm
belowpivotshaft)contactstheendoftheslot(just
beginningtoputpressureonthespring)(Figure64).
7.Checkwherethecontrolleverisrelativetonotchin
console(Figure64).Itshouldbecenteredallowing
levertopivotoutwardtotheneutrallockposition.
1
2
3
G001046
Figure64
1.Neutrallockedposition3.Neutralposition
2.Controllever
8.Ifadjustmentisneeded,loosenthenutandjamnut
againsttheyoke(Figure65).
47