Toro 74909TE User Manual

76 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

FormNo.3404-792RevB

ZMaster

®

Professional6000

SeriesRidingMower

with132cmTURBOFORCE

®

SideDischarge

Mower

ModelNo.74909TE—SerialNo.316000001andUp

g035384

Registeratwww.Toro.com.

OriginalInstructions(EN)

*3404-792*B

Table of Contents

Questions and Answers:

P
Paul HarrisAug 25, 2025
Why does my Toro Lawn Mower engine not start, start hard, or fail to keep running?
- N
  nwashingtonAug 25, 2025
  Several factors can cause your Toro Lawn Mower engine to fail to start, start with difficulty, or stall. Here are a few things to check: * Ensure the fuel tank is full. * Verify the fuel-shutoff valve is open. * Check that the oil level in the crankcase is adequate. * Position the throttle control midway between the slow and fast positions. * Replace a dirty fuel filter. * Clean or replace the air-cleaner element. * Check the spark-plug wire connection and adjust or replace the spark plug, if needed. Also, inspect the seat-switch indicator and replace the seat if necessary and check the electrical connections for good contact, cleaning them with electrical-contact cleaner and applying dielectric grease.
C
Christina SmithSep 2, 2025
What to do if my Toro Lawn Mower won't drive?
- J
  Jonathan PerkinsSep 2, 2025
  If your Toro Lawn Mower isn't driving, check if the bypass valves are not closed tight and tighten them. Also, the pump belt could be worn, loose, or broken, or off a pulley, in which case change the belt. The idler spring might be broken or missing, so replace the spring. The hydraulic-fluid level might be low or too hot, so add hydraulic fluid to reservoirs or let it cool down.
S
Stephen PerkinsSep 2, 2025
How to troubleshoot uneven cutting height on my Toro 74909TE Lawn Mower?
- M
  michaelrussellSep 2, 2025
  An uneven cutting height on your Toro Lawn Mower could be due to several factors. The blade(s) might not be sharp, so sharpen them. Alternatively, the cutting blade(s) could be bent, so install new cutting blade(s). The mower deck might not be level, so level the mower deck from side-to-side and front-to-rear. The underside of the mower could be dirty, so clean it. Also, the tire pressure might not be correct, so adjust it.
E
Eric GarciaSep 1, 2025
Why aren't the blades rotating on my Toro 74909TE?
- B
  Brandy WhiteSep 2, 2025
  If the blades on your Toro Lawn Mower aren't rotating, check for a damaged, worn, loose, or broken mower deck belt and install a new deck belt if needed. If the mower deck belt is off the pulley, install it back on the deck pulley and check the idler pulley, idler arm, and spring for correct position and function. Inspect the pump drive belt for wear, looseness, or breakage; check the belt tension or install a new belt. Replace the idler spring if it is broken or missing.
J
Jonathan LeeSep 1, 2025
How to fix uneven cutting height on my Toro 74909TE?
- A
  Alexis PittsSep 1, 2025
  If the cutting height is uneven on your Toro Lawn Mower, consider these possibilities: * Sharpen the blade(s) if they are not sharp. * Install a new cutting blade(s) if the current ones are bent. * Level the mower from side-to-side and front-to-rear. * Adjust the anti-scalp wheel height if an anti-scalp roller (if applicable) is not set correctly. * Clean the underside of the mower deck if it is dirty. * Adjust the tire pressure if it is incorrect.
J
Joseph CarterSep 1, 2025
How to fix a starter that won't crank on my Toro 74909TE?
- D
  Dorothy Cortez DVMSep 1, 2025
  If the starter on your Toro Lawn Mower won't crank, check these items: * Ensure the blade-control switch is disengaged. * Engage the parking brake. * Move the motion-control levers to the NEUTRAL-LOCK position. * Make sure you are sitting in the operator’s seat. * Charge the battery if it's dead. * Check the electrical connections for good contact. * Replace the fuse if it's blown.
K
Karen RaySep 1, 2025
Why does my Toro Lawn Mower have an uneven cutting height?
- A
  Ashley VanceSep 1, 2025
  An uneven cutting height on your Toro lawn mower can result from: - Dull blades: Sharpen the blade(s). - Bent cutting blades: Install new cutting blade(s). - Unlevel mower deck: Level mower deck from side-to-side and front-to-rear. - Dirty mower underside: Clean the underside of the mower. - Incorrect tire pressure: Adjust the tire pressure.
M
mary47Aug 31, 2025
How to fix Toro 74909TE Lawn Mower engine when it loses power?
- D
  Daniel ReevesAug 31, 2025
  If your Toro lawn mower engine loses power, try reducing the ground speed, as the engine load may be excessive. Check and clean the air cleaner element if it's dirty. Ensure the oil level in the crankcase is sufficient. Clear any obstructions from the cooling fins and air passages above the engine. Also, inspect the fuel cap vent hole and clean or replace the fuel cap if it's plugged, and replace the fuel filter if it is dirty.
D
Dakota CohenAug 31, 2025
What to do if my Toro 74909TE Lawn Mower will not drive?
- M
  Matthew LopezAug 31, 2025
  If your Toro Lawn Mower won't drive, consider the following: * Tighten the by pass valves. * Change the belt. * Replace the spring. * Add hydraulic oil to reservoirs or let it cool down.
T
Thomas LeeAug 31, 2025
What to do if my Toro 74909TE blades do not rotate?
- A
  andrewgillAug 31, 2025
  If the blades on your Toro Lawn Mower do not rotate, try these solutions: * Install a new deck belt. * Install the mower deck pulley and check the idler pulley, idler arm, and spring for correct position and function. * Check the belt tension or install a new belt. * Replace the spring.

Toro 74909TE Specifications

General

Brand	Toro
Model	74909TE
Category	Lawn Mower
Language	English

Related product manuals

Preview: Toro 74906

Preview: Toro 74902TE

Preview: Toro 74901 Z Master 5000

Toro 74901 Z Master 5000

Preview: Toro 74952

Preview: Toro 74995