Toro 74915 - Page 63

g027343
Figure91
1.Deck-liftpedal
3.Transportlock
2.Height-of-cutpin
6.Inserttheheightadjustmentpinintothe76mm
(3inches)cuttingheightlocation.
7.Releasethetransportlockandallowthedeckto
lowertothecuttingheight.
8.Raisethedischargechute.
9.Onbothsidesofthedeck,measurefromthe
levelsurfacetothefronttipoftheblade(Postion
A)asshowninFigure92.
Note:Themeasurementshouldread76mm
(3inches)
g009196
Figure92
1.76mm(3inches)at
positionAiscorrect
3.Measureherefromthe
bladetiptothehard
surface
2.83mm(3-1/4inches)at
positionBiscorrect
4.MeasureatpositionAand
Bonbothsides
10.Ifneeded,loosenthewhizlocknutonthesideof
theyokeandthejamnutontop(Figure93).
11.Finetunethescrewadjusterbyturningittoget
76mm(3inches)height.
Note:T oincreasetheheight,turnthe
adjusterscrewclockwise;todecrease,turnit
counterclockwise.
Note:Ifthefrontdecklinksdonothaveenough
adjustmenttoachieveaccuratecutheight,the
singlepointadjustmentcanbeutilizedtogain
moreadjustment.
63