Toro 74915 - Page 64

g027344
Figure93
1.Whizlocknut3.Jamnut
2.Adjusterscrew
4.Yoke
12.Toadjustthesinglepointsystem,loosenthe
2boltsatthebottomoftheheight-of-cutplate
(Figure94).
g027345
Figure94
1.Boltsatthebottomoftheheight-of-cutplate
13.Ifthedeckistoolow,tightenthesinglepoint
adjustmentboltbyrotatingitclockwise.If
thedeckistoohigh,loosenthesinglepoint
adjustmentboltbyrotatingitcounterclockwise
(Figure95).
Note:Loosenortightenthesingle-point
adjustmentboltenoughtomovethe
height-of-cutplatemountingboltsatleast1/3
thelengthoftheavailabletravelintheirslots.
Thisregainssomeupanddownadjustmenton
eachofthe4decklinks.
g009042
Figure95
1.Single-pointadjustmentbolt
14.Tightenthe2boltsatthebottomofthe
height-of-cutplate(Figure94).
Note:Inmostconditions,thebackbladetip
shouldbeadjusted6.4mm(1/4inch)higher
thanthefront.
15.Torquethe2boltsto37to45N∙m(27to33ft-lb).
16.Onbothsidesofthedeck,measurefromthe
levelsurfacetothebacktipoftheblade(postion
B)asshowninFigure92.
Note:Themeasurementshouldread8.3cm
(3-1/4inches)
17.Finetunethescrewadjusterbyturningittoget
8.3mm(3-1/4inches)height(Figure93).
Toincreasetheheight,turntheadjustmentnut
clockwise;todecrease,turncounterclockwise.
18.Measureuntilall4sidesarethecorrectheight.
19.Tightenallofthenutsonthedeck-lift-arm
assemblies.
20.Lowerthedischargechute.
64