Toro 74922 - Controls System Maintenance; Adjusting the Control-Handle Position

7.Removethebeltfromthehydraulicunitdrivepulleys
andtheenginepulley.
8.Installthenewbeltaroundenginepulleyandthe2
drivepulleys.
9.Usingaratchetinthesquareholeintheidlerarm,
installtheidlerspringtotheframe(Figure79).
10.Installthemowerbelt;refertoReplacingtheMower
Belt(page51).
ControlsSystem
Maintenance
AdjustingtheControl-Handle
Position
Thereare2heightpositionsforthecontrollevers—highand
low .Removetheboltstoadjusttheheightfortheoperator.
1.DisengagethePTO,movethemotion-controlleversto
theneutral-lockedposition,andsettheparkingbrake.
2.Stoptheengine,removethekey,andwaitforallmoving
partstostopbeforeleavingtheoperatingposition.
3.Loosentheboltsandangenutsinstalledinthelevers
(Figure80).
4.Aligntheleversinthefront-to-rearpositionby
bringingtheleverstogethertotheneutralposition,and
slidethemuntiltheyarealigned,thentightenthebolts
(Figure81).
Figure80
1.Bolt
3.Controllever
2.Handle4.Nut
53