EasyManua.ls Logo

Toro 74939 - Brake Maintenance; Adjusting the Parking Brake

Toro 74939
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
BrakeMaintenance
AdjustingtheParkingBrake
ServiceInterval:Aftertherst100hours
Every500hoursthereafter
Makesurebrakeisadjustedproperly.Thisproceduremust
befollowedwhenabrakecomponenthasbeenremovedor
replaced.
1.Drivethemachineontoalevelsurface.
2.Disengagethebladecontrolswitch(PTO),movethe
motioncontrolleverstotheneutrallockedposition
andsettheparkingbrake.
3.Stoptheengine,waitforallmovingpartstostop,and
removethekey.
4.Raisethebackofthemachineupandsupportthe
machinewithjackstands.
DANGER
Mechanicalorhydraulicjacksmayfailto
supportmachineandcauseaseriousinjury.
Usejackstandwhensupportingmachine.
Donotusehydraulicjacks.
5.Removethereartiresfromthemachine.
6.Removeanydebrisfromthebrakearea.
7.Rotatethedrivewheelreleasehandletothereleased
position.RefertotheUsingtheDriveWheelRelease
Valves(page27).
8.Measuretheoveralllengthofthecompressionspring.
Thecorrectlengthshouldbebetween3.8and4.0
cm(1-1/2and1-9/16inches).Ifthespringlengthis
withinthisrange,noadjustmentisneeded.Ifitisnot,
proceedtostep9.
9.Holdthethreadedrodendwithatoolandadjustthe
locknutuntilthespringlengthisbetween3.8and4.0
cm(1-1/2and1-9/16inches)(Figure76).Donotallow
thecabletoturnwhenthenutsarebeingloosened.
Figure76
LeftHandBrakeShown
1.Cableanchor5.Caliper
2.Holdthreadedrodhere
6.Compressionspring
3.Measure7.Threadedrod
4.Locknut8.Hub
10.Disengagetheparkbrake.
11.Turnthewheelhubbyhandinbothdirectionsrelative
tothecaliper;nodragofthecaliperpadonthewheel
hubisdesired.
12.Ifthereisnomovementbetweenthehubandthe
caliperthenrepeattheadjustment(drivereleasevalves
mustbeinthereleasedpositiononthehydros).
13.Afteradjustingthebrakesonbothsidesofthemower,
cyclethebrakehandleaminimumof6timestoallow
thecabletoseatintothesheathandmountingtabs.
14.Checkthespringlength;engagetheparkbrakeand
repeatsteps8through12ifthelengthisnotinthe
correctrange.
15.Rotatethedrivewheelreleasehandletotheoperating
position.Refertothe
UsingtheDriveWheelRelease
Valves(page27)
.
16.Installthereartiresandtorquelugnutsbetween90and
95ft-lb(122and129N-m).
17.Removejackstands.
48

Table of Contents

Related product manuals