Toro 74942TE - Adjusting the Anti-Scalp Rollers

AdjustingtheHeight-of-CutPin
Adjusttheheight-of-cutfrom25to140mm(1to
5-1/2inches)in6mm(1/4inch)incrementsbymovingthe
clevispinintodifferentholelocations.
1.MovethetransportlocktotheLOCKposition.
2.Pushonthedeck-liftpedalwithyourfootandraise
themowerdecktotheTransportposition(alsothe
140mmor5-1/2inchcutting-heightposition)as
showninFigure26.
3.Toadjust,rotatethepin90degreesandremovethepin
fromtheheight-of-cutbracket(Figure26).
4.Selectaholeintheheight-of-cutbracketcorresponding
totheheight-of-cutdesired,andinsertthepin(Figure
26).
5.Pushonthedecklift,pullbackonthetransportlock,
andslowlylowerthemowerdeck.
Figure26
1.Deck-liftpedal
3.Transportlock
2.Height-of-cutpin
AdjustingtheAnti-scalp
Rollers
Wheneveryouchangetheheightofcut,adjusttheheight
oftheanti-scalprollers.
1.Disengagetheblade-controlswitch(PTO),movethe
motion-controlleverstotheNEUTRAL-LOCKposition
andsettheparkingbrake.
2.Shutofftheengine,removethekey,andwaitforall
movingpartstostopbeforeleavingtheoperating
position.
3.Adjusttheanti-scalprollersasshowninFigure27and
Figure28tomatchtheclosestheight-of-cutposition.
g024242
1
2
3
4
Figure27
1.Flangenut3.Bushing
2.Anti-scalproller4.Bolt
g024243
1 2 3
4
Figure28
1.Bolt3.Anti-scalproller
2.Bushing4.FlangeNut
25