Toro 74953 - Page 56

Figure85
1.Deck-liftpedal
3.Transportlock
2.Height-of-cutpin
6.Inserttheheight-adjustmentpinintothe7.6cm(3
inch)cutting-heightposition.
7.Releasethetransportlockandallowthedecktolower
tothecuttingheight.
8.Raisethedischargechute.
9.Onbothsidesofthedeck,measurefromthelevel
surfacetothefronttipoftheblade(PostionA).The
measurementshouldread7.6mm(3inches);referto
Figure86.
Figure86
1.7.6cm(3inches)atAis
correct
3.Measureherefromthe
bladetiptohardsurface
2.8.3cm(3-1/4inches)atB
iscorrect
4.MeasureatAandBon
bothsides
10.Ifneeded,loosentheangedlocknutonthesideofthe
yokeandthejamnutontop.Fine-tunetheadjuster
screwbyturningittoget7.6mm(3inch)height
(Figure87).
Note:Toincreasetheheight,turntheadjuster
screwclockwise;todecreasetheheight,turnit
counterclockwise.
Figure87
1.Flangedlocknut3.Jamnut
2.Adjusterscrew4.Yoke
11.Ifthefrontdecklinksdonothaveenoughadjustment
toachieveaccuratecutheight,thesinglepoint
adjustmentcanbeutilizedtogainmoreadjustment.
12.Toadjustthesinglepointsystem,loosenthetwobolts
atthebottomoftheheight-of-cutplate.Referto
Figure88.
Figure88
1.Boltsatthebottomoftheheight-of-cutplate
13.Ifthedeckistoolow ,tightenthesinglepoint
adjustmentboltbyrotatingitclockwise.Ifthedeckis
56