EasyManua.ls Logo

Toro 74955 - Adjusting the Motion-Control Linkage

Toro 74955
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Figure78
AdjustingtheMotion-Control
Linkage
Locatedoneithersideofthefueltank,belowtheseatarethe
pump-controllinkages.Rotatingthepumplinkagewitha
1/2inchwrenchallowsne-tuningadjustmentssothatthe
machinedoesnotmoveinneutral.Anyadjustmentsshould
bemadeforneutralpositioningonly.
WARNING
Theenginemustberunningandthedrivewheels
mustbeturningsothatthemotion-control
adjustmentcanbeperformed.Contactwithmoving
partsorhotsurfacesmaycausepersonalinjury.
Keepngers,hands,andclothingclearofrotating
componentsandhotsurfaces.
1.Priortostartingtheengine,pushthedeck-liftpedal
andremovetheheight-of-cutpin.Lowerthedeckto
theground.
2.Raisetherearofmachineupandsupportitwithjack
stands(orequivalentsupport)justhighenoughto
allowthedrivewheelstoturnfreely.
3.Removetheelectricalconnectionfromtheseatsafety
switch,locatedunderthebottomcushionoftheseat.
Note:Theswitchisapartoftheseatassembly.
4.Temporarilyinstallajumperwireacrosstheterminals
intheconnectorofthemainwiringharness.
5.Starttheengine.
Note:Thebrakemustbeengagedandthe
motion-controlleversmustbeouttostartthe
engine.Theoperatordoesnothavetobeinthe
seatbecauseofthejumperwirebeingused.Run
theengineatfullthrottleandreleasethebrake.
6.Runthemachineatleast5minuteswiththe
motion-controlleversatfullforwardspeedtobringthe
hydraulicoiluptooperatingtemperature.
Note:Themotion-controlleverneedstobeinneutral
whilemakinganynecessaryadjustments.
7.Bringthemotion-controlleversintotheneutral
position.
8.Adjustthepump-controlrodlengthsbyrotatingthe
doublenutsontherodintheappropriatedirection
untilthewheelsslightlycreepinreverse(Figure79).
Figure79
1.Doublenuts
9.Movethemotion-controlleverstothereverseposition,
andwhileapplyingslightpressuretothelever,allow
thereverseindicatorspringstobringtheleversback
toneutral.
Note:Thewheelsmuststopturningorslightlycreep
inreverse.
10.Shutoffthemachine.Removethejumperwirefrom
wireharnessandplugtheconnectorintotheseat
switch.
11.Removethejackstands.
12.Raisethedeckandinstalltheheight-of-cutpin.
13.Checkthatthemachinedoesnotcreepinneutralwith
theparkbrakesdisengaged.
52

Table of Contents

Related product manuals