Toro 74955 - Mower Deck Maintenance; Leveling the Mower Deck

MowerDeck
Maintenance
LevelingtheMowerDeck
SettingUptheMachine
Note:Ensurethemowerdeckisleveledbeforematchingthe
height-of-cut(HOC).
1.Positionmoweronaatsurface.
2.Disengagethebladecontrolswitch(PTO),movethe
motioncontrolleverstotheneutrallockedposition
andsettheparkingbrake.
3.Stoptheengine,removethekey,andwaitforallmoving
partstostopbeforeleavingtheoperatingposition.
4.Checktirepressureofthetires.Ifneeded,adjustto
90kPa(13psi).
5.Positionthemowertothe76mm(3inch)height-of-cut
position.
LevelingtheDeck
1.Positionthemoweronaatsurface.
2.Stopengine,waitforallmovingpartstostop,and
removekey.Engageparkingbrake.
3.Checkthetirepressureinthedrivetires.Proper
inationpressurefortiresis90kPa(13psi).Adjust
ifnecessary.
4.Positionthetransportlockinthelatchingposition.
5.Pushthedeck-liftpedalallthewayforwardandthe
deckwilllatchatthe14cm(51/2inch)transport
position(Figure85).
Figure85
1.Deck-liftpedal
3.Transportlock
2.Heightofcutpin
6.Inserttheheightadjustmentpinintothe7.6cm(3
inch)cuttingheightlocation.
7.Releasethetransportlockandallowthedecktolower
tothecuttingheight.
8.Raisethedischargechute.
9.Onbothsidesofthedeck,measurefromthelevel
surfacetothefronttipoftheblade(PostionA).The
measurementshouldread7.6mm(3inches)(Figure
86).
Figure86
1.7.6cm(3inches)atAis
correct
3.Measureherefromthe
bladetiptohardsurface
2.8.3cm(31/4inches)atB
iscorrect
4.MeasureatAandBon
bothsides
56