Toro GrandStand 74574 - Page 57

Figure87
1.Measurethebladeat
pointsAandB
2.Measurefromalevel
surface
4.Ifitisnotcorrect,refertoChangingtheMowerDeck
Front-to-RearPitch(page57).
ChangingtheMowerDeck
Front-to-RearPitch
Changingthefront-to-rearpitchisdonebyadjustingthe
frontheight-of-cutposts.
1.Place3piecesof2x4woodunderthemowerdeckas
showninFigure88.
2.Standthe2x4piecesonthe4-inchpart.
g026975
Figure88
1.2x4pieceofwoodunderthemowerdeck
3.For48and52-inchmowerdecks,loosenboththefront
andrearnutsontheadjustmentrods(Figure89).
4.For60-inchmowerdecks,loosenboththefrontand
rearnutsandliftlinksontheadjustmentrods(Figure
90).
Note:Theweightofthemowerdeckmustberesting
onall3ofthe2x4pieces(Figure89).
Note:Thebacklipofthemowerdeckisbuilt6mm
(1/4inch)lowerthanthefrontlipofthemowerdeck.
5.For60-inchmowerdecks,tightentheliftlinks(Figure
90).
6.Tightenboththefrontandrearnuts.
7.Checkthefront-to-rearpitchofthecuttingunit.
8.Ifthedimensionsarenotcorrect,adjustthefrontand
rearnutsoneithersidetogetthecorrectfront-to-rear
pitch(Figure89).
g026976
Figure89
48and52-inchmowerdecks
1.Adjustmentrods3.Frontnuts
2.Rearnuts
57